High Flow™ Air Horn Intake Kit for 00-05 Edge,
06-09 600 HO, 07-12 600/700 Cleanfire IQ and
08-10 800 HO
The SLP High Flow™ Air Horn Intake Kits converts the top of your airbox to
increase intake air velocity. This gives more available air volume into the
airbox, improving atomization efficiency of fuel, in turn improving throttle
response and delivering an additional 3 horsepower peak. Good improvement
for stock sleds, mandatory for modified ones. Best when used with two Flow-
Rite™ Intake Kits on Edge models or an Upper Dash Vent for IQ models.
167-14107 00-02 Edge XC
167-14115 02-05 Pro X & RMK, 03-05 XC 06-09 600
HO IQ Carb
167-14123 07-12 600 HO CFI IQ / 700 H.O. CFI, 08-10
Also see complete High Flow™ Intake Kits.
High Flow™ Intake for SkiDoo-BRP XP (except
This High Flow™ Intake Kit for the SkiDoo-BRP XP increases the air intake
surface area by 33% to reduce the chance of the intake plugging in powder
snow conditions. It is located higher than the stock intake and within reach of
the rider so that any snow that collects on it can be easily wiped away. This kit
consists of a molded plastic adapter that seals between the stock air box and
the hood along with an intake grate that utilizes our pre-filter material that
repels snow and water while passing air right through. This kit is a must for
anyone riding powder snow conditions.
High Flow™ Air Horn Intake Kit for Firecat & M7
This High Flow™ Air Horn Intake Kit provides more airflow to your engine,
which improves throttle response, peak horsepower and running consistency. A
good improvement for stock sleds, mandatory for modified ones.
167-14291 M7 Models
167-14292 Firecat Models
High Flow™ Intake for SkiDoo-BRP REV except RT
The REV’s stock air intake is restrictive and because of its placement, it is prone
to plugging with powder snow and ice. This results in a significant loss in
horsepower, which makes the sled very inconsistent when running in deep snow
conditions. This High Flow™ Intake Kit corrects these problems by providing
more than double the intake surface area for added airflow to the engine. Its
placement, as well as its design, which utilizes a powder snow pre-filter that
repels snow and water, reduces the tendency of powder snow and ice plugging
by shedding the snow rather than allowing it to build up.
High Flow™ Intake Kit for Crossfire 8/M8/HCR,
800/100 Crossfire R/CRF Crossfire 1000/M1000
The stock M and Crossfire 800/1000 intake is quite restrictive, primarily in
the nose of the hood where the air intake tapers down and connects to the
bellows. We have eliminated this restriction by increasing the volume of the air
intake in this area. This intake kit further maximizes consistency by utilizing two
additional vents that are positioned low and forward. These vents draw in cold
dense air, even when the upper outside stock intake vents get partially plugged
in deep powder snow. It increases midrange power for better throttle response
and delivers an additional 2 horsepower peak.
167-14305 2007-11 800/1000 Models