
Right side drive trap door puller
Use this tool to properly remove the transmission trap door. Use on all
JIMS® Right Side Drive transmissions and other aftermarket right side drive
transmissions.
53-0998 Use on all right side drive transmission
1230 IRON
ROAD1 8
Connecting rod bushing tool
Use to remove and replace wrist pin bushings in Twin Cam 88, without
removing connecting rod from crankcases.
53-0579 Use on all Twin Cam 88, 99-06 FL, 99-05 FXD, 00-06 FXST
Crankshaft bearing tool
This quality tool is designed to remove and replace the right crankcase bearing.
Precision made and piloted using delrin, a non-marring material, to press
bearing in and out straight with no damage to the case. Use on all Twin Cam
88™.
53-0572 99-02 Twin Cam Alpha Only
Twin Cam Case saver oversize tappet reamer
This tool can be a case saver if you have worn out or damaged tappet bores
on any Twin Cam engine case. This reamer tool is designed to ream the case
to fit a JIMS® (53-2353) oversize Twin Cam Powerglide™ II lifter. This tool
includes a top quality reamer designed for this application and two Flex-Hones,
to perform a perfect finish hone on each tappet hole.
Tappet Powerglide™ II Tappet.
53-2353 Use on all Twin Cam 1999 to present
Beta engine interconnect seal leak testing tool
Yet another tool to properly inspect your lower end assembly before sealing
the cases. This new tool will check the sealing of the interconnect seal H-D
No.45359-00. Use the tool along with a Jim’s Leakdown Tester. This test
assures you that there is no leakage in the seal that can cause over oiling of the
lower end. Use on all Beta Twin Cam engines 2000 to present.
53-2375