1635 90° Banjo 10mm (3/8”) Part # 51-R4394C Quantity: 1 3/8” - 24 Inverted Flare 45º End for Rear Caliper Part # 51-R4382C Quantity: 1 3/8” - 24 Inverted Flare 90º End Long for Junction Block/Caliper Part #51-R4385C Quantity: 1 35° Banjo 10mm (3/8”) Part # 51-R4391C 7/8” Part # 51-R4393C Quatity: 1 PRO SYSTEM SERIES -3 Straight Hose End Part # 51-R2013C* Quantity: 1 Banjo Straight 10mm (3/8”) Part # 51-R4390C 3/8” - 24 Inverted Flare Straight for Front Caliper Part # 51-R4381C Quantity: 1 3/8” - 24 Inverted Flare 90º End Short for Junction Block/Caliper Part # 51-R4384C Quantity: 1 Pro system I hose with clear coat Engineered for the professional bike builder, Pro System I hose is a 308 stainless steel -3 braided hose specifically designed for high performance brake applications.It features a Teflon® inner liner along with a clear or tinted coat for abrasion resistance to painted surfaces. Maximum operating pressure is 2500 PSI. Available with clear coat or smoke tinted coat. Does not meet D.O.T. specifications Length Size Clear coat 51-R3180 10’ -3 51-R3182 20’ -3 Smoke tint coat 51-R3482 20’ -3 -3 Replacement Ferrule Part # 51-R20135* Quantity: 10 -3 90° Hose End Part # 51-R2044C* Quantity: 1 Pro System 1 Replacement Ferrule Part # 51-R49008 Quantity: 10 Pro system I compression hose end fittings The Pro System I chrome plated compression hose end-fittings are designed to ensure a positive seal. Use in conjunction with the Pro System I braided hose for brake hose connections between the master cylinder, junction block and caliper. *For use with 51-R2013C and 51-R2044C only. How To Assemble Pro System I Fittings 1) Wrap tape tightly around hose where cut is to be made. 2) Using either a cut off wheel or fine tooth hack saw, cut hose to desired length. 3) With a sharp knife, trim back the clear coating approx. 1” from end of hose. 4) Disassemble the 3-piece adapter fitting. 5) Slide the tapered nut (taper first) over the hose. 6) Using a small screw driver, separate and open up the stainless braid from the Teflon® inner liner. 7) Slip the brass ferrule (tapered end towards the hose) over the Teflon® inner liner. 8) Lubricate barb with brake fluid and insert the barbed end of the fitting into the Teflon® tube. 9) Draw up the tapered nut and tighten down. Note: To re-use Compression fittings, you must replace the ferrule. Be sure to choose the correct ferrule for your fitting.
To see the actual publication please follow the link above