Page 1267

2017roadiron-cruiser_en

1267 Bearing and race puller tool This tool has been designed to remove the flywheel sprocket shaft inner bearing race with the supplied JIMS T-bar and hardware. • Use on Twin Cams 2003 to present • Use to remove Timken bearing (H.D. No.9028) or No.9029 on Big Twins, 1955 Panhead to present Twin Cam, including JIMS 120” engines. • Use to remove the flywheel sprocket shaft inner bearing race or the Timken bearing. Also removes pinion shaft inner bearing race on Sportster 1954 to present, including all Buell’s to present. • Use to correctly remove press fit transmission gears and bearings from input and output shafts on all V-ROD models 2002 to present. 53-2318 Twin Cam Case saver oversize tappet reamer This tool can be a case saver if you have worn out or damaged tappet bores on any Twin Cam engine case. This reamer tool is designed to ream the case to fit a JIMS® (53-2353) oversize Twin Cam Powerglide™ II lifter. This tool includes a top quality reamer designed for this application and two Flex-Hones, to perform a perfect finish hone on each tappet hole. 53-2349 Use on any Twin Cam engine, OEM or aftermarket Tappet Powerglide™ II Tappet. 53-2353 Use on all Twin Cam 1999 to present H-D Cruise Drive 6-speed main drive gear remover tool This tool removes the main drive gear from the main bearing correctly while in the transmission case. This eliminates the need of an arbor press and the risk of case damage. 53-2348 Use on all Twin Cam H-D 6-speed Cruise Drive models 2006 Dyna’s & all 2007 to present Twin Cam models Beta Case Support Block Tool The Beta Case support block tool, JIMS® No. 916 was submitted to JIMS® as a tool idea from MMI Instructor Derek Beck on our “ JIMS® Tool Submission Program”. This innovative tool is designed to protect the left engine case while servicing the inner balancer bearings or performing other general engine work. These blocks attach to the outer side of the engine case underneath the balancer bearing pads surface. The blocks are made of aluminum and have an inserted Delrin pad that rest against the case to prevent marring. The blocks properly support the case, keeping it on a level plane when using a press for bearing service work. These tools blocks also keep the case level when using JIMS® tool 53-2346 to remove the balancer bearings without an arbor press. 53-2351 Use on all beta Softail® Twin Cam models 2000 to present. Beta Balancer inner bearing Remover/installer JIMS® tool will accurately, and safely install or remove the inner balancer bearing mounted in the left engine case. This tool is designed for early or late Beta cases and can all be done on a work bench without using an arbor press. 53-2346 Use on all beta Twin Cam models 2000 to present Inner primary cover bearing and seal installer/ remover tool Designed to safely remove and install the inner primary bearing, (H.D. No.9135) without any damage to the new bearing. This is done by pushing on the outer perimeter of the bearing. Also removes and installs inner primary seal, (H.D. No.12052A). This is the bearing and seal that the transmission mainshaft passes through. Use on Late 1984-2006 FXST, 1985-2006 FL, 1985-2006 FXR, FXD. 53-2321


2017roadiron-cruiser_en
To see the actual publication please follow the link above