Page 616

2017moto_en

588 BLACK VINYL - STOCK AND SPECIAL LENGTH CABLES (CONT.) CC Model Cable Year Fn BV BV Throttle BV Throttle BV Throttle Choke Clutch CW Clutch LW Decom- Front Hot Start Speedo Tach Length Throttle PP Pull Push pression Brake Yamaha (cont.) 1300 XVS 1300A V-Star Std 07-08 06-5291 06-5292 06-5293 1300 XVS 1300A V-Star -1.0” 2008 06-5293 1300 XVS 1300A V-Star Std 2009 06-5291 06-5292 1300 XVS 1300A V-Star Std 2012 06-5291 06-5292 1300 XVS 1300CT V-Star Tourer Std 07-08 06-5291 06-5292 06-5293 1300 XVS 1300CT V-Star Tourer -1.0” 2008 06-5293 1300 XVS 1300CT V-Star Tourer Std 09-14 06-5291 06-5292 1300 XVS 1300CT V-Star Tourer -1.0” 12-14 06-5293 1300 XVS 1300CTF V-Star Deluxe Std 13-14 06-5291 06-5292 1300 XVS 1300CTF V-Star Deluxe -1.0” 13-14 06-5293 NOTES 001 Requires 4WD switch relocation kit part# 11-0024 (not included). 002 Requires 4WD switch kit 11-0033 (not included). 003 Requires 11-0032 4wd switch relocation kit (not included) 004 Top cable only 005 Also fits stock throttle 006 Built before 2/10/99 007 Built after 2/10/99 008 Requires 01-0033 carb cap 009 Use with stock carb(s) requires carb cap(s) (01-0023) & adjuster(s) (01-0013). Eliminates TORS system & stock carb cap(s). Requires idle kit (08-0045) when used with stock carb(s) (sold separately). Warning - Disables the T.O.R.S. system and will not shut down engine in case throttle sticks open. A stuck throttle could result in uncontrolled acceleration and great bodily injury or death. This product is intended for closed course racing by expert riders only. Improper installation could result in great bodily injury or death. User assumes all responsibility for proper installation and use of this product. 010 Fits stock carb with stock carb caps only 011 For use with stock throttle 012 Also fits stock throttle 013 Fits FCR 41 014 For use with FCR carbs 015 Fits Domino throttle to Keihin FCR 016 Fits stock thumb throttle 017 Fits handlebar mounted hot start lever 018 Warning - This kit disables the T.O.R.S. system and will not shut down engine in case throttle sticks open. A stuck throttle could result in uncontrolled acceleration and great bodily injury or death. This product is intended for closed course racing by expert riders only. Improper installation could result in great bodily injury or death. User assumes all responsibility for proper installation and use of this product. 019 Includes 4x4 Switch Relocation Kit. 020 Includes carb cap p/n 01-0020, cap is attached to cable. 021 Kit includes carb cap p/n 01-0022, remove 0020 & replace 022 Includes carb cap p/n 01-0021, cap is attached to cable. 023 Non CA models only (For 49 state) 024 CA models only 025 Requires 11-0026 4x4 Switch Relocation Kit for 4WD models (11-0026 sold separately) 026 Top cable only 027 T2 Gray cable 028 Rear hand brake 029 Rear foot brake 030 Works with stock throttle cable 031 WARNING. This throttle is extremely fast and is recommended for closed course off road racing by expert riders only. 032 Grips included 033 This cable will replace either push or pull throttle cables (both cables are the same) 034 Early 1984 only 035 Early 1976 only 036 Early 1980 only 037 Late 1984 only 038 Late 1976 only 039 Late 1989 only 040 Late 1988 only 041 Late 1978 only 042 Late 1985 only 043 Can only be used without cruise control 044 Early 1985 only 045 W/S&S Super E or G carbs. This cable replaces Idle or Throttle side cables. 046 01-0233 Fits pull and push side with stock throttle. Or use 01-0234 with Mikuni smooth bore kit and 01-0058 throttle assy. 01-0234 Fits push side of 01-0058 throttle. 01-0233 fits pull side of 01-0058 throttle. 047 Warning - Disables the T.O.R.S. system and will not shut down engine in case throttle sticks open. A stuck throttle could result in uncontrolled acceleration and great bodilyinjury or death. This product is intended for closed course racing by expert riders only. Improper installation could result in great bodily injury or death. User assumes all responsibility for proper installation and use of this product. 048 Warning - Agricultural throttle is for low speed farm use only. Not for sport orrecreational use. 049 For adding optional Sigma electronic odometer sensor pick-up on SX models for 98-02 models use 10-0104 050 For adding optional Sigma electronic odometer sensor pick-up for 2003 and latermodels use 10-0103 051 Requires use of 01-0465 to stock front brake. 052 requires use of 14-0105 to stock front brake 053 For 2006 Polaris Sportsman 500 EFI built before 01/16/06 054 For 2006 Polaris Sportsman 500 EFI built after 01/16/06 055 With CDI only 056 With breaker points 057 01-1019 Cable for use with 01-0053 CR Pro throttle only. Not for 01-0056 CR Comp.Carb cap included. 058 For use with stock thumb throttle. Warning - Disables the T.O.R.S. system and will notshut down engine in case throttle sticks open. A stuck throttle could result inuncontrolled acceleration and great bodily injury or death. This product is intended forclosed course racing by expert riders only. Improper installation could result in greatbodily injury or death. User assumes all responsibility for proper installation and useof this product. 059 Does not fit SV650S 2003-2007; SV650SA 2007 060 Same as 08-0425 except 08-0372 has a 14 mm crankshaft thread protector 061 1.5 inches longer than stock 062 Sensor pin assembly not included with Motion Pro lever. Remove Sensor pin assemblyfrom lever being replaced and install on new Motion Pro lever. 063 “Same puller body as 08-0372 (C08-0372A), but with thread protector C08-0257B.“ 064 Uses snap-in fitting at thumb throttle. OEM cable uses bayonet fitting at thumb throttle 065 4WD switch relocation kit 11-0033 included with kit 066 Specially designed for SV650S with clip-on bars. Routes through cylinder V. 067 Please check size needed, OEM changed rotors through production run.Puller size onsome models may require 18mm flywheel puller 08-0116 068 Please check size needed, OEM changed rotors through production run.Puller size onsome models may require 16mm flywheel puller 08-0027 069 Warning: This kit disables the stock throttle override system. This kit will not shut offthe engine if your throttle or carb sticks in the open position. A stuck throttle couldresult in uncontrolled acceleration and great bodily injury or death. This product isintended for closed course racing by expert riders only. This product must be installedby experienced professional mechanic. Improper installation could result in greatbodily injury or death. User assumes all responsibility for proper installation and use of this product. 070 Includes carb cap P/N 01-0039. Cap is attached to cable. 071 Fits Stock Carb; 4WD models require 11-0030 4x4 Switch Relocation Kit, soldseparately. 072 +2.5 in. Housing is longer than OEM cable to allow for after-market clamps, bars,dampers, etc. 073 For use with stock fuel injection 074 Fork Bleeder Kit requires drilling, tapping and end milling of fork cap. Kit includes5/16 inch tap and 9/32 inch drill bit. Requires 7/16 inch end mill (not included). 075 Non-USA Model 076 Requires 01-0742 cable with Stock Carb. 077 Requires 01-0236 cable w/ stock carb 078 For use with stock carb 079 For use with stock throttle bodies and Revolver throttle assembly only. IMPORTANT - The Revolver VR throttle does not have the starter and kill switch wiring or switchesthat are built into your stock throttle assembly. Use of the Revolver VR Throttlerequires an aftermarket kill switch and starter button assembly (pn 11- 0057) notincluded in kit. 080 Two inches longer than stock cable 081 “Warning: Installation of this kit requires drilling and tapping the carburetorbody. Installation of this kit requires a high degree of skill and should only be doneby an experienced mechanic with proper equipment (a drill press or mill is recom- mended). Improper installation will damage your carburetor. Motion Pro is notresponsible for damage to carburetor resulting from misuse or improper installation.“ 082 Item discontinued 083 WARNING The Vortex throttle will open your carburetor to full throttle in just 46degrees of twist (1/8 turn). This throttle is extremely fast and is recommended forclosed course off-road racing by expert riders only. 084 WARNING: The Consumer Product Safety Improvement Act prohibits sale of this leveron vehicles intended for use by children 12 years or under. This lever also fits otherbikes and ATVs designed for adult use and may be sold for use on adult model bikesand ATVs and for pit bike conversions for use by adults and children over 12. Thislever may not be sold for use on bikes or ATVs intended for use by children ages 12years or under. 085 WARNING: The Consumer Product Safety Improvement Act prohibits sale of this leverfor for use on bikes or ATVs designed for children ages 12 years or under. 087 WARNING: Due to lead content, this product is intended for use on vehicles modifiedfor adult use or for use by children over 12 years of age. The Consumer ProductSafety Improvement Act prohibits sale of this product for use by children under 12 years of age. 088 Revolver cables can only be used with stock throttle body (or carburetor whereapplicable) and Revolver throttle 089 Fits WP 4357,4860 series forks with fork spring preload adjuster and 4860 MXMA CCseries forks


2017moto_en
To see the actual publication please follow the link above