Page 309

2017moto_en

281 2 wire pack 321-7428 DW-1200 2 wire suppression 90° gray 4 wire pack 321-7421 DW-200 4 wire copper black 321-7422 DW-300 4 wire copper red 321-7424 DW-600 4 wire suppression black 321-7426 DW-800 4 wire suppression gray 321-7427 DW-1100 wire suppression graphite black 315-7058 Spark plug jack 0636-172 12-11501 Spark plug jack Boot/Term type Terminal type Cable Length 26-CR1 Straight CR1 Threaded 50 cm 26-CR2 Elbow CR2 Threaded 50 cm 26-CR3 Straight CR3 Solid post 50 cm 26-CR4 Elbow CR4 Solid post 50 cm 26-CR5 Elbow CR5 Threaded 100 cm 26-CR6 Elbow CR6 Solid post 100 cm 321-7422 321-7421 12-11501 26-8035 Cable 26-8035 NGK Racing Solid Threaded Change your wires in 3 easy steps! Economic instead of changeing your existing CDI system. The NGK Cable Splicer joins your existing CDI system to the NGK Hi Performance Racing Cable for a quick, complete installation! Splicer use with 7mm wire 26-J-1 No. Cyl Boot/Term type Core Type 07-170085 2 90° Stainless Steel/Copper 07-173083 2 90° Graphite Suppression 07-173082 4 90° Graphite Suppression Coil wires DYNA Wires are available with a solid copper core for use on older vehicles where electrical interference is not an issue. For use on new vehicles with electronic advance ignitions or other sensitive electronic equipment use DYNA suppression wires with a high grade graphite core for best performance and electrical noise suppression. Both wire types ensure maximum energy transfer and a 135 degree snap boot for easy installation Twin spark plug jack • Holds two 14mm spark plugs • Universal NGK ignition wire With an outer insulator of rugged high performance silicone, and an inner core of solid copper wire stands, these new racing wire sets from NGK will help you get to the winner’s circle. Connected with NGK resistor covers in either straight or 90° configurations. Accel 8.8 universal fit ignition wire sets 8.8 mm wires available in stainless steel / copper or graphite RFI suppression core. One 42” wire is included in the two cylinder set. Each wire end is terminated with a 90° spark plug boot. The hardware kit includes locking spark plug type terminals, boots for male coil towers, brass distributor type terminals and boots for female coil towers, and instructions for easy installation. Made in U.S.A. 315-7058 RACING WIRES AND ACCESSORIES


2017moto_en
To see the actual publication please follow the link above