Page 764

2016snowmobile

High Flow™ Intake for SkiDoo-BRP REV except RT chassis models High Flow™ Intake for SkiDoo-BRP XP (except The REV’s stock air intake is restrictive and because of its placement, it is E-TEC) prone to plugging with powder snow and ice. This results in a significant This High Flow™ Intake Kit for the SkiDoo-BRP XP increases the air intake loss in horsepower, which makes the sled very inconsistent when running in surface area by 33% to reduce the chance of the intake plugging in powder deep snow conditions. This High Flow™ Intake Kit corrects these problems by snow conditions. It is located higher than the stock intake and within reach of providing more than double the intake surface area for added airflow to the the rider so that any snow that collects on it can be easily wiped away. This kit engine. Its placement, as well as its design, which utilizes a powder snow pre- consists of a molded plastic adapter that seals between the stock air box and filter that repels snow and water, reduces the tendency of powder snow and the hood along with an intake grate that utilizes our pre-filter material that ice plugging by shedding the snow rather than allowing it to build up. repels snow and water while passing air right through. This kit is a must for anyone riding powder snow conditions. 167-14119 High Flow™ Intake Kit for REV 167-14122 Intake Grate Only for REV 167-14129 High Flow™ Intake, XP (except) E-TEC SLP Flow-Rite™ Intake Kits Eliminate air intake restrictions by installing the Flow-Rite™ in the dash for more air box feed. The Flow- Rite™ is supplied with a powder snow pre-filter that repels snow and water, yet passes air right through. A must for modified sleds. Sold per each. #167-14189 and 167-14194: SLP part numbers 167-14189 and 167-14194 are made using a rubber flange to attach the Flow-Rite™ to the surface that Inside Outside Hole it is being installed in. This rubber flange conforms itself to a wide variety of Diameter diameter diameter contoured, shaped and textured surfaces for a universal mounting system. inches inches 167-14197: SLP part number 167-14197 is designed for ease of installation 167-14194 2” 2 11/16” 2 3/8” on flat or nearly flat surfaces. It requires a 2 1/2” size hole saw, which is 167-14197 * 2” 2 3/4” 2 1/2” readily available from any hardware store. Installation is a snap: hole saw 167-14189 2 1/2” 2 1/2” 3 1/8” the hole, debur the edges, clean hole saw shavings and snap Flow-Rite™ into * Snap-In style Flow Rite™ (Part #167-14197) is recommended for use in the dash only. place. Use rubber flange style for other locations. Polaris Edge: 2” Polaris GEN II: 2 1/2” IQ RMK/Switchback: 2” Ski-Doo ZX: 2” Yamaha Viper: 2 1/2” Yamaha SX & MM: 2 1/2” 764


2016snowmobile
To see the actual publication please follow the link above