Page 157

2016snowmobile

WOODY’S® TOOL Woody’s® Studhex Tool Use this tool for installing and removing push- through studs. The handle is made from premium aluminum. Each tool comes with an extra hex bit. Replacement hex bit are also available in sets of two Woody’s Pre-holed rubber mud Green Wheeler grinding strap wheel Fits all models. • Special grade grinding wheel designed 389-9758 Stud hex tool specifically for sharping carbide runners and studs 389-9759 Replacement bit 389-8639 6” green wheel (1/2”) 389-9158 AGW-4000 6” green wheel (1”) 389-9159 AGW-4100 hand grinding wheel • Black silicon grinding wheel allows you to sharpen carbide runners right on the ski • Fits Shallow socket tool most hand grinders • Follow manufacturers safety Tightens studs without touching surface of the instructions support plate will install studs up tp 1.575 in length 389-9153 AGW-4500 389-8915 Shallow Socket 7mm 389-8916 Shallow Socket 5/16” Stud sharpening tool 389-8912 Stud-sharpening tool 30° 389-8913 Stud-sharpening Tool 45° 389-8914 Stud-sharpening Tool 60° 389-8990 Replacement Inserts (4) Spec gauge (improved) Indexing Tool Totally redesigned template to verify the use of For Square support Plates studs and carbide runners used in racing (oval track, acceleration or rough terrain) encounters 389-8742 5/16” legal standards. The maximum height allowed 389-8743 7mm for track racing in rough terrain is 3/8 ". Height 389-9704 5/16” Grand Gigger for drag racing is 3/4 ". The maximum height of smooth wear is 5/8 "while the angle must not exceed 60 °. Woody’s track saver™ tool 389-9157 ASG-4100 For standard and short barrel t-nuts This tool is invaluable for removing or installing standard and short barrel T-Nuts. Three pins fit the T-Nut prong slots and will hold it firmly in place. This tool snaps on any 3/8» drive ratchet. 389-8780 Spring Tool Triangle indexing Tool Woody's Spring Tool gives you better leverage to get to those hard to reach areas. Use this tool to Align your Digger support plates by using this push, pull or twist springs into place. Made in the specialized Indexing Tool. To be used with a 3/8” ratchet. Can be used for both 5/16” and 7mm USA Triangle Digger® support plates. 389-8455 Spring Tool 10'' 389-8787 Spring Tool 15" 389-8766 SPI-TOOL-T 157


2016snowmobile
To see the actual publication please follow the link above