Page 1304

2016roadiron

1304 Flywheel sockets Use on Big Twin® (1954-early 81) 53-0022 1-5/16” x 1/2” drive (1029-TS) Use to install or remove crank case pin nut 53-0192. 23966-54A Use on Big Twin® (late 1981-89) 53-0024 1-1/4” x 1/2” drive (1031-TS) Use to install or remove pinion shaft nut 53-0215. 24016-80 Use on Sportster® (1954-early 81) 53-0020 1-5/16” x 1/2” drive Use to install or remove crank pin nut 53-0193 Use on Big Twin® (1983-1999) Single Cam 53-0023 1-1/2” x 1/2” drive (1030-TS) Use to install or remove crank case pin nut 53-0194. 23969-83 Use on Big Twin® (1972-1999) Single Cam 53-0025 1-5/8” x 3/4” drive (1032-TS) Use to install or remove sprocket shaft nut 53-0216. 24017-80 Use on Sportster® (1981-99) and Use on Buell® (1987-99) 53-0026 1-3/8” x 1/2” drive (1033-TS) Use to install or remove crank pin nut 53-0183. 23901-81 Balanced shaft bearing remover & installer Performs like JIMS® other bearing removers by simplifying bearing removal. This tool will pull the bearings from the “B” motor case in one easy smooth motion preventing any damage to the bearing bores. The installing portion of this tool is designed to push on the outer diameter of bearings preventing any damage to the bearing or it’s bore. Use installer portion of this tool with JIMS® tool No. 33416-80. 53-0856 Use on Twin Cam 2000 to 2006 “B” model Softails.(1167) Piston support plate Using this tool will give you peace of mind when installing your rings and cylinders by providing a non-marring flat support to push the bottom of the piston agents as you install the rings and cylinder over the piston. 53-0858 Use on all H-D® style engines (1164) Balancer shaft retention pins Use this tool to secure the engine balancers on Twin Cam 88TM “B” engines when servicing the flywheel assembly. This tool locks into the balancer’s sprocket pin holes to prevent the balancer from turning out of sync with the flywheel. 53-0857 Use on Twin Cam 2000 to present “B” model Softails (1163) Sprocket shaft seal installer Use this kit to install the sprocket shaft seal to the proper depth and also for holding the seal perfectly square, for a no leak fit. Driver handle sold seperately, order handle. #53- 0149. 53-0160 Sportster® (74-03), Buell® (87-02) Sprocket shaft bearing installation tool Use to install crank shaft assembly into crankcase Timken® bearings. Use with 53-0553. Use tool 53-0427 to install the bearing until tool runs out of threads, then install 53- 0428 to push the bearing on the rest of the way. 53-0427 2.060” long Sportster® (77-03) Buell® (87-03) 53-0428 2.500” long Sportster® (77-03) Buell® (87-03)


2016roadiron
To see the actual publication please follow the link above