Page 1303

2016roadiron

1303 Case lap tool Use on Big Twin® (1958-1999). Single Cam 53-0546 (96710-TL) Head Holder (valve guide remover and installer) Comes with adapters to fit all H.D.® and aftermarket heads. Adapters are supported by a support stand. Makes pressing valve guides in and out simple. A special guide alignment shaft is designed into this tool. This shaft holds the right angle for the best possible guide installations. Save time and money by installing the guides, in line, with the valve seats, time and time again for much less seat grinding. 53-0143 Snap ring installing & remover tool This tool will remove and install Timken® bearing outer race snap ring, without damage to case. Use on Big Twin® (1969-present). 53-0064 (1710) Timken® bearing simulator This tool is designed to allow quick and easy removal and replacement of flywheel assembly in the left side crankcase when checking rod to case, piston to flywheel or cylinder to flywheel clearance. Use on Big Twin® (70-02). 53-0080 (1745) Timken® bearing race installer Use to install bearing races in left crankcase. use this precision tool to press in bearing races straight time after time. In 69-UP cases use JIMS® tool 53- 0527. For removal of Big twin races, see previous page. Use on Big Twin® (69-02), Sportster® (77-03) and Buell® (87-03). 53-0147 (2246) Tool driver spacer Use with driver tool 53-0355/ 53-0527/... The effectiveness of any bearing race remover tool is dependent on the ability to grip the race. This spacer applies outward force on the bearing race tool, to grip the race better, allowing easier removal of race. Use on all bearing race tools. 53-0182 (2388)


2016roadiron
To see the actual publication please follow the link above