Page 1301

2016roadiron

1301 Piston pin bushing tool Use to remove and install wrist pin bushings without removing rods from crankcase. Use on Evo®. 53-0543 Piston lock ring tool Use to install lock ring H.D. No 22582-52 in piston having .515” I.D. wrist pins, like most aftermarket pistons. Use on Big Twin® and Sportster® (1973 and earlier). 53-0549 Piston lock ring tool Use to install lock ring H.D. No 22582-52 in piston having .535” I.D. wrist pins. Use on Big Twin® and Sportster® (1973-77). 53-0550 Piston pin keeper tool For installing and removing split ring "L" type keeper. Use on Big Twin® (32-72). 53-0548 Rod alignment tool Use to check rod straigntness without removing rods from case. The alignment tool is 4-1/2” long. Instruction sheet. Use on all Big Twin®. 53-0850 Use on JIMS® Twin Cam® rods with .827” diameter wrist pins 53-0851 Use on all Twin Cam® 88TM, “A” & “B” and S&S rods with .927” diameter wrist pins. 53-0008 Use on all Big Twin® rods (Single Cam) with .791” diameter wrist pins Rod race tool Support both sides of rod as races are removed or replaced minimizing the possibility of distortion to female rod or race. Use on all Big Twin®. 53-0004 Crank disassembly removing tool Use to press flywheels from cases (Will also press cases apart and break sealant bond). Some case pressing will require a hard cap 53-0038. On Twin Cam® “B Motor” - This tool can only be used for removing the flywheel from the left case. 53-0037 Use 55 to 06 Big Twins except 2006 Dyna. Works on most aftermarket engines. Rod lapping set Arbor assembly includes 1-1/2” and 1-5/8” laps. Use on all Big Twin®. 53-0547 Piston pin keeper tool Use to install retaining ring in piston. This tool will install ring in one easy step without distorting ring, for the safest wrist pin retention possible. Use on Big Twin® (83-99), Sporstster® (late 85-UP) and Buell® (87-UP). 53-0375 Wrist pin clip remover/installer Use this tool to easily remove wire type wrist pin clips without damage to the piston. 53-0866 Use on EVO® 1984-99 engines Inner cam bearing installation tool This tool easily presses the inner cam bearing smoothly into the right case with the cases assmembled to the proper depth. Uses JIMS® tool(53-0540) to remove bearing. Use on Big Twin® (58-99). (Single Cam only) 53-0127 Hard cap Use to protect sprocket shaft when using JIMS® tool (53-0037) or a press. Use on Big Twin® (55-06). 53-0038


2016roadiron
To see the actual publication please follow the link above