Page 1299

2016roadiron

1299 Tappet oil filter screw plug tool Use to remove tappet oil filter screen plug without removing exhaust pipes. Use on Big Twin® with slotted screw. (Single Cam) 53-0135 Tappet oil filter screw plug tool • O-ring design retails the tool in a 7/16’’ wrench or socket Hex 7/16’’ drive allows more rotation without contacting engine cases. • Flange design allows downward force to be applied to tool. • For use on Big Twin® (excluding Twin Cam®) with slotted screw tappet oil filter screen cover. • Can be used without removing exhaust pipes on most bikes. • A recommended service at every oil change. 08-0339 Breather reamer tool Repair a damaged breather hole with JIMS® Breather Reamer Tool. No need to disassemble the cases. Using JIMS® Reamer Tool will repair a damaged breather hole, to use a .030” oversize breather gear, (see breather gear section in this catalog), in less than an hours time. IMPORTANT NOTE: Some early crankcases 1936-69, have very little material between the breather hole and the air/oil separator cavity below it. Before using the 53-0562, measure the wall thickness to verify that the reamer will not break through. 53-0562 Use on all Big Twin Single Cam 36-99 NOTE: All holes in breather bore will need to be cleared of all chips). Oil pump seal installer Easily installs oil pump seal perfectly below gear surface for a no leak fit. Use on all aluminum Big Twin® pumps. (Single Cam only) 53-0041 Tapet position holding tool Expert technicians know that keeping the same parts operating in their original position and direction is a good idea. This is especially true with the tappets in Harley-Davidson® engines. Whenever the tappets are removed, in the case of a camshaft change or complete tear down, our new Tappet Position Holding Tool allows the tappets and anti rotation pins to be safely and accurately stored for proper reinstallation. Tappet locations are clearly referenced on the tool, which also serves to protect the tappets from damage when removed from the engine. For all Twin Cam® engines 1999 to present and 2000 to present XL and Buell (except 1125R). 53-2749


2016roadiron
To see the actual publication please follow the link above