Page 823

2013 RI Cruiser

Clutch spring compression tool This new clutch spring compression tool is made for Big Twin 1340cc models from 90-98 and all XLH 883/1200cc models from 91-98. Will assist in the removal and installation of the clutch assembly. Sold as a kit.Replaces HD OEM # HD-38515-A 08-337 Brake caliper piston remover This tool will support the brake caliper pistons for removal by holding the pistons square to their bores. This prevents any damage to the pistons and the piston bores so seals & wipers can be replaced. 53-0855 Use on all H-D®, 4 piston For pricing, visit www.motovan.com in the dealer section. 823 brake calipers 2000-present (1162) Balancer shaft alignment tool This tool is a must have for maintaining a long life of your balancer’s drive chains and bearings. This tool will take all the guess work out of setting up your sprocket and chain alignment on a “B” Beta Twin Cam Softail engine. Treat this too with great care, just as you would treat a micrometer. 53-0854 Use on all Twin Cam 2000 to present “B” model softails (1166) Clutch puller Works on 3, 5 & 10 finger clutch hubs and pulls clutch hub on Big Twin® & 45 inch models. Also pulls motor sprocket on Sportster Big Twin® and Sportster® transmission sprockets and rotor assembly on Big Twin®. 08-959 H.D.® 95960-52 Clutch and flywheel tool Perfect for holding clutch baskets, flywheels, gears, sprockets, etc. when assembling and dissassembling. Hardened jaws open to 5”. Better torque control than an air gun. 08-008 51-HD1 51-HD2 Diaphragm clutch spring compression tools Makes it easy to remove and re-install retainer ring. 51-HD1 Fits 1990 and later Big Twins® and 1991 and later Sportsters® 51-HD2 Fits 1984-90 Sportsters® 51-HD3 (H.D. # 97175-55) 51-HD4 Fits 1941-84 Big Twins® Imperial Valve Spring Compressor • Jaw in one piece for easy replacement of locks. • Fits almost all small engines. • Ability to spring 9/16". Includes regular and small jaws. 315-1300 Push rod tool Designed to remove and install the clip in Harley-Davidson push rod tubes. Flat portion of tool fits under cylinder head while cupped end fits over the bell in the tube and then compresses the spring allowing for easy access to spring cap retainer.No more cut knuckles & scratched engine parts from using a screwdriver between the fins. 08-0172


2013 RI Cruiser
To see the actual publication please follow the link above