Page 812

2013 RI Cruiser

PINION GEAR TOLS Pinion gear nut socket Use to remove or secure pinion gear nut to pinion gear shaft. 1/2” drive. Use with JIMS tool (53- 0138) locker. Use on Big Twin® (1955-1992) 53-0529 H.D. #94555-55A Pinion gear installer collar Use to install pinion gear to correct position on shaft, use with JIMS® tool (53-055) pinion gear installer and puller. Use on XL® (1957-76) and on K model (1952-1956). 53-0067 Pinion gear installer & puller Use to install pressed on splined gears on Big Twin® (1939-53). Use to remove pinion gear on Big Twin® (1939-89) and Sportsters® (1957-76). 53-0551 Pinion gear locker tool Use to lock pinion gear, necessary to torque the pinion nut.Use JIMS® tool (53-0529) to tighten pinion nut. Use on Big Twin® (1954-present) and S&S motors 53-0138 Oil pump snap ring installer Easily install outer snap ring on oil pump shaft, without stretching the ring. Just apply oil to ring expander, slip ring up to the big end of ring expander, hold up to the end of the shaft, then push ring onto the shaft with sleeve. Use on all Big Twin oil pumps single cam only. Aftermarket and S&S® motors. 53-0040 JIMS® pinion bushing drill jig Use to install and drill dowel pin hole in pinio bushing at the stock location 349-6172 93-99 Evolution Big Twin Late Shovel® & Evo® tappet block aligment tool Use to align oil hole from crank case tappet block. Get two, and use to align rocker boxes on Evo® heads. Use on Big Twin® (late 1976-present) and S&S. 53-0370 812 For pricing, visit www.motovan.com in the dealer section. (exc. Twin CYLINDER TOLS Dental pik 53-0174 Cylinder jig assembly Use to repair stripped damaged cylinder base threads up to a 4” bore, in engine case. This tool will hold centerline and squareness to where the factory intended them to be. All this with the engine still in the frame using an angle head drill (drill not included). Use on Big Twin® (1984-present), Sportster® (1986-present) and Buell® (1987-present). 53-0001 Cylinder torque plates Late model aluminum cylinders cannot be accurately honed without using torque plates! Simulates stress conditions when boring or honing. The JIMS® torque plates are drilled for multiple application use, and can accomodate up to a 4” bore. To use with Sportster®. Order both. 53-0042 Buell® (1987-2003) Sportster® (1986-2003) Big Twin® (1966-1999) 53-0117 Use these 4 bolts when using torque plates with Evo Sportster®/ Buell®


2013 RI Cruiser
To see the actual publication please follow the link above