Page 807

2013 RI Cruiser

Twin Cam® tool board This tool board comes ready with holders and shadowed for 12 Twin Cam tools. Board is ready to hold the following (actual tools are not included): 53-0572 Crankshaft bearing tool 53-0580 Cam bearing tool 53-0579 Connecting rod bushing tool 53-0571 Wrist pin remover 53-0577 Cam chain tensioner tool 53-0569 Crankshaft guide 53-0578 Cam/Crank sprocket lock tool 53-0574 Cam shaft remover and installer 53-0575 Cylinder torques plates 53-0576 Inner cam bearing remover tool 53-0581 Crankshaft bushing tool 53-0573 Inner cam bearing installer For pricing, visit www.motovan.com in the dealer section. 807 53-0740 Tool Board WITHOUT tools TWIN CAM TOLS Connecting rod bushing tool Use to remove and replace wrist pin bushings in Twin Cam 88TM, without removing connecting rod from crankcases. Use on all Twin Cam 88™ 53-0579 Wrist pin remover This new Jims® tool will cut the time it takes to remove wrist pin, this simple tool can be used easily by one person.No need to get another technician to hold the piston while you drift the pin out. 53-0571 Use on all models. (Note : includes Twin Cam 88TM) Cylinder torque plates To check cylinder measurements accurately these torque plates are essential. These plates simulate stress conditions when boring and honing. These plates are lasered with the correct torqueing sequence and will fit Screaming Eagle® big bore cylinders. 53-0575 Use on all Twin Cam 88TM. (99-up) Inner cam bearing remover tool Designed like our popular EVO cam bearing tool, it removes the bearing easily without any damage to the crankcase.This precision built tool will also keep the pin rollers from accidentally falling into the crankcaseUse on all Twin Cam 88TM 53-0576 Cam bearing puller Once the camshafts are removed from the support plate, this specialty tool will remove the bearing from the camshaft. Unlike a general purpose puller this tool was designed to remove the bearing straight with no slipping or binding. Use on all Twin Cam 88™ 53-0580 Cam shaft remover & installer This multi-function tool will remove and replace front and rear camshaft and the ball bearings in the new Twin Cam 88TM .It provides the precision alignment of the camshaft to ensure a smooth press in and out of the support plate. Use on all Twin Cam 88™ 53-0574 Wrist pin bushing reamer tool (use with rods in or out of motor) Use this kit to ream your wrist pin bushings to H.D.® specifications.These reamers are made to exact tolerances, piloted to locate from the I.D. of your newly replaced Jims® wrist pin bushings. Reams are easy to use with their designed lead in taper at the start of each ream. 53-0887 Big Twin, Twin Cam Rod Holding tool 53-0563T Reamer Twin Cam 88TM 53-0563 Big Twin 73-99 Reamer 53-0563X XL 57-up Buell 87-up Reamer Cam chain tensioner tool This tool will unload the pressure on the primary and the secondary chain tensioners to assemble and disassemble cams. This tool also checks spring loads on chain tensioners. Use on all Twin Cam 88™ 53-0577


2013 RI Cruiser
To see the actual publication please follow the link above