Page 806

2013 RI Cruiser

Pivot bearing remover Use this tool to remove and install all Softail swing arm pivot bearings. This tool may also be used to remove and install the spherical bearing on Springer front fenders. This tool will remove and install the bearings straight and true, without any damage. 53-0747 Use a Big Twin 1984-present FXST models, or any after markets swingarm that uses H.D.™ Bearing number 9076. Also use on Big Twin 1997 2002 & 2004-present Springer Softails. Front Fenders that use H.D.™ Bearing number 9194. Fork stem bearing remover Use this tool to remover the lower fork stem (triple Clamp) tapered bearing. 53-0746 Use on all lower fork stems that use an H.D.™ number 48300-60 style bearing. Order Jims™ hard end cap, NO1048 when using an early XL 1954 to 77 Speedo re-calibration This electronic speed correction module from Dakota Digital will plug into your speed sensor harness to correct the speedometer and odemeter after a change in tire size, pulley size or transmission gearing. This unit plugs directly between the stock transmission sensor and stock speedometor. No cutting or splicing is required. This module can correct the speedometer to within 1 mph from 50% to 200% of the original reading. 53-0748 Use on all Big Twin 1996-present & XL 1999-present. Pulley lock tool Sportster Sprocket Locker Tool Use this tool to lock the final drive sprocket when removing and installing the sprocket nut. 53-0809 For use on all Sportsters 1991-present. “EVO” case boring tool The new JIMS™ EVO case boring tool takes all the guess work out of boring the engine case cylinder spigot bore. You can bore any EVO style case (H.D.™ or aftermarket) having a stock size cylinder stud bolt pattern. Stock 80” EVO has a 3.5” cylinder bore. For Example: • Tool with bore any EVO style engine case with stock bolt pattern, up to 3.8125". This tool can be used with a heavy duty 15" drill press. Simply locate and affix the tool to a 15" drill press, install the precision boring cuter fixture (Utilizing the stock Cylinder Stud Holes), set the RPM and depth - start Boring. 53-0749 Use on 1984 to 1999 EVO style engine cases. Bore fron stock bore size to 3.8125” bore size. Will work with aftermarket engine cases that utilize stock bore size up to 3.8125” 806 For pricing, visit www.motovan.com in the dealer section.


2013 RI Cruiser
To see the actual publication please follow the link above