Page 805

2013 RI Cruiser

Cruise Drive 6-Speed trans door remover tool Use this tool to remove (pull) the complete door with gears and shafts from the transmission. No longer will you need to remove the trap door by prying or hitting with a hammer. Just prepare the trans for disassembly, bolt this tool to the outside of door, and place the two supplied press pins into the two screw holes of trans case. Thread in two of the screws, securing the door to cases, and the door is pulled from the case. 53-0984 Use on all 06-up Dyna and 07-up FLHT, FXST Valve Spring Compressor for use on the new conical valve springs Add this collar to your JIMS® valve spring compressor tool No. 53-0545 to remove and replace valves and conical (Bee hive) H/D No. 18245-02 springs, a must have tool for safe valve work. Use on all ’05 to present BT’s (except on SE models), all ’04 to present XL’s & Buell Twins. 53-0988 53-0545 Spring compressor Cruise Drive 6-speed main drive gear installer tool Use this tool to safely install a new or newly repaired main drive gear. This job can be performed with the transmission still in the frame, with hand tools. This tool will hold the main drive gear square to its bearing bore, eliminating any marring of gear or bearings. 53-0981 Use on all 06-up Dyna and Cam assembly tool Use to hold both cams in an upright position while lowering the cam support plate over both guides and cam journal guides. This tool has been manufactured from a non-marring material, that will not damage any of the cams’ surfaces. 53-0990 Use on all TC, 06-up Dyna and 07-up FL, FXST Inner cam bearing remover tool Use this tool to press in the two inner cam bearings. JIMS® No. 53-0078 came bearings. This tool has been designed to press from letter side of the inner cam bearings, by putting all the pushing pressure to the very outer wall of bearing shell. Eliminating any damage to the bearings, cam and cases. This tool will stop at the case and set the bearing depth to .023” to .028” below the case surface. A must use for the longest bearing and cam life. Use with JIMS® Tool No. 53-0993 53-0993 Removal tool, use on all TC, 06-up Dyna and 07-up FLHT, FXST For pricing, visit www.motovan.com in the dealer section. 805 07-up FL, FXST All Twin Cam transmission stand Use with base stand No. 53-0870 53-0992 Use on 99-up 53-0870 Base Stand Cam/crank sprocket lock tool This precision tool allows the technician to lock the camshaft and crankshaft sprockets to properly remove, replace, and torque the sprocket bolts. This tool is made from non-marring Delrin. 53-0994 Use on all TC, 06-up Dyna and 07-up FL, FXST 53-0578 Use on all TC, 99-06 FL, 99-05 Dyna and 00-06 FXST Cruise Drive shift fork shaft remover tool Use this tool to loosen and remove both shifter shafts from trans door, allowing further disassembly of trans. Use on 2006 to present Dyna models. 53-0985 Use on all 06-up Dyna, 07-up FLH, FXST Fork leg and tube holder tool Use this tool to hold fork legs and tubes for easy hands free servicing or rebuilding. Mounts in a vise to hold the fork firmly during repair without causing damage to the fork assembly. Will not scratch finishes. 53-0745


2013 RI Cruiser
To see the actual publication please follow the link above