Page 802

2013 RI Cruiser

Inner primary cover bearing and seal installer/remover tool Designed to safely remove and install the inner primary bearing, (H.D. No.9135) without any damage to the new bearing. This is done by pushing on the outer perimeter of the bearing. Also removes and installs inner primary seal, (H.D. No.12052A). This is the bearing and seal that the transmission mainshaft passes through. Use on Late 1984-2006 FXST, 1985-2006 FL, 1985-2006 FXR, FXD. 53-2321 25mm Wheel bearing puller tool This tool used to remove the new front 25mm H.D. wheel bearings on most of the 2007 to present Softail models. 53-2323 49mm Fork seal and dustshield installer tool This tool is designed to install the lower leg 49mm fork seal squarely into the bore without damaging the seal lip surface. Also used to install the dust shield cover. It is a two-piece design to aid in some assembly applications.Use on all FXD’S, 2006 to present and all V-ROD’S 2002 to present (except inverted fork models). 53-2322 Gasket locator tool This tool will assist you in aligning the gaskets to avoid misalignment and oil leaks. Primary cover, cam cover, and transmission end cover gaskets are just a few of the possible applications. Install the locator tools into the gasket surfaces 1/4”-20 threaded holes, slip on the gasket and the cover over the pins. Next, install a few cover mounting screws and snug down. Recover the tools and finish off with the remaining screws. Use on all models with 1/4”-20 threaded gasket surface mounting holes. 3 piece set. 53-2324 Outer balancer bearing installer & remover tool This tool removes and installs the outboard balancer bearing on the new 96” & 110” “B” Softail engines chain guide support plate. Use on all Softails 2007 to present. 53-2326 Timken Bearing or Race Installer Adapter Kit This tool will upgrade your earlier JIMS No.97222- 55 bearing installer tool to work on the latest fine spline Twin Cam sprocket shafts. Designed to either install (H.D. No.8028) Timken bearing or the roller bearing race assembly (H.D. No.24004-03) onto the sprocket shaft. Use on Big Twins 2006 to present FXD’S or 2007 to present FXST’S & FL’S. Also use on JIMS 120” engines. 53-2331 Clutch Assembly Service Tool for Big Twins This tool will safely disassemble and assemble the clutch shell assembly. Easily removes and installs the clutch hub from it’s bearing. Safely removes and installs the clutch shell ball bearing (H.D. No.37906-90) without any damage to the new bearing. This is done by pushing on the outer perimeter of bearing. Use on Big Twins 1990 to present. 53-2332 FL Power train alignment tool This tool easily and safely aligns the Power Train, (rubber mounted engine, transmission and the swingarm assembly) to the correct position as found on most touring models. Alignment service must be performed when the engine, transmission, or swingarm has either been removed or repaired. The safety in handling and performance of the motorcycle could be greatly effected without the accurate alignment this tool provides. Use on 1993 to present FLHT models. 53-2327 802 For pricing, visit www.motovan.com in the dealer section.


2013 RI Cruiser
To see the actual publication please follow the link above