Page 801

2013 RI Cruiser

Beta Balancer inner bearing Remover/installer JIMS® tool will accurately, and safely install or remove the inner balancer bearing mounted in the left engine case. This tool is designed for early or late Beta cases and can all be done on a work bench without using an arbor press. 53-2346 Use on all beta Twin Cam models 2000 to present Twin Cam Case saver oversize tappet reamer This tool can be a case saver if you have worn out or damaged tappet bores on any Twin Cam engine case. This reamer tool is designed to ream the case to fit a JIMS® (53-2353) oversize Twin Cam Powerglide™ II lifter. This tool includes a top quality reamer designed for this application and two Flex- Hones, to perform a perfect finish hone on each tappet hole. 53-2349 Use on any Twin Cam engine, OEM or aftermarket Tappet Powerglide™ II Tappet. 53-2353 Use on all Twin Cam 1999 to present Beta Case Support Block Tool The Beta Case support block tool, JIMS® No. 916 was submitted to JIMS® as a tool idea from MMI Instructor Derek Beck on our “ JIMS® Tool Submission Program”. This innovative tool is designed to protect the left engine case while servicing the inner balancer bearings or performing other general engine work. These blocks attach to the outer side of the engine case underneath the balancer bearing pads surface. The blocks are made of aluminum and have an inserted Delrin pad that rest against the case to prevent marring. The blocks properly support the case, keeping it on a level plane when using a press for bearing service work. These tools blocks also keep the case level when using JIMS® tool 53-2346 to remove the balancer bearings without an arbor press. 53-2351 Use on all beta Softail® Twin Cam models 2000 to For pricing, visit www.motovan.com in the dealer section. 801 present. Rear axle nut torque adapter This JIMS® tool will make adjusting the drive belt tension or rear wheel alignment a bit easier. It will save you time by eliminating the need to remove the mufflers to perform this service. The tool is designed with a 1/2” drive receiver hole for inserting your torque wrench thus letting you torque the axle nut from an offset possition. 53-2347 Use on all 2006 to present FL Touring models H-D Cruise Drive 6-speed maindrivegear remover too This tool removes the main drive gear from the main bearing correctly while in the transmission case. This eliminates the need of an arbor press and the risk of case damage. 53-2348 Use on all Twin Cam H-D 6-speed Cruise Drive models 2006 Dyna’s & all 2007 to present Twin Cam models H-D Cruise Drive 6-speed maindrive gear & bearing remover/installer kit This is a complete kit for servicing the main drive gear or the main bearing on the latest H-D® 6-speed transmission. This precision tool removes or installs both parts correctly without damaging the case. 53-2350 Use on all Twin Cam H-D 6-speed Cruise Drive models 2006 Dyna’s & all 2007 to present Twin Cam models H-D® Cruise Drive 6-speed trap door bearing remover/installer This innovative tool will accurately install a lubed ball bearing into the transmission trap door. Also removes bearing without error and can be performed on a work bench, no need for an arbor press. 53-2352 Use on all Twin Cam H-D 6-speed Cruise Drive models 2006 Dyna’s & all 2007 to present Twin Cam models


2013 RI Cruiser
To see the actual publication please follow the link above