Page 1434

2013 Moto En

1434 Safety wire starter kit 08-SWW400 Safety wire kit 307-0637 Tool only 08-SWW590 Safety wire washers (18) 08-SW413 Safety wire (.032”x25’) 08-SW360 Safety wire 1lbs (approx. 360'.) • New ultra-compact, low profile design is only 11mm for high installed • Stainless steel body is stronger and will not corrode • Easy to install simply replace the OE bleeder screw with the Micro Bleeder • Reduce harshness caused by air build-up • Allows bleeding of air pressure without tools • One of the easiest bold-on upgrades you can make to your forks • Kit includes two bleeder valves Rotor and sprocket holder Master cyclinder snap-ring pliers Allows removal of internal snap rings in hydraulic master cylinders. • Replaces 07914-SA50001 and AKS-316-2010. • Can be used to remove and replace small to medium internal snap rings up to 50mm deep, including those used for transmission gear location, bearing retention, and oil seal retention. • Applicable to some fork seal retaining rings • Keeps flywheels, rotors and sprockets from rotating while removing or tightening their fixing adjuster • Holds sprockets and rotors with holes center to center at a minimum distance of 13mm and a maximum distance of 230mm • Features 5 and 9mm pins • Adjustable stop-screw keeps tool open at set distance. 08-0270 08-0279 MTV disk brake piston spreader Ideal to draw aside the pistons of clamp of brake without damaging the plates or the disc. Excel to maintain the element in position open during the replacement of the tires or change of wheel. 08-3993 M4X0.7, WP 4860 MXMA, Black For 2007 or later SX/SXF/XC/XCF/XCW models with WP 4860 MXMA CC Closed Cartridge fork caps (P/N 4860.0516S1). And for use on all 1999 and later WP 43/WP 48 fork caps (P/Ns 4860.0074S and 4860.0075S) with external spring preload adjustment. These fork caps require a 4-pin spanner (MP P/N 08-0290) to remove the fork cap. 08-110080 M4X0.7, WP 43-48 W/O Ext Preload, Orange For use on all 1999 and later WP 43/WP 48 fork caps (P/N's 4860.0020s and 4860.0020S1) without external spring preload adjustment. These fork caps DO NOT require a pin spanner to remove the fork cap. 08-110081 M5X0.8, Silver For use on most Kayaba and Showa inverted forks with a M5x0.8 air bleed screw in the fork cap 08-110082 Mini Bleeder • Combines wrench and bleeder valve into one convenient and compact tool • Fits most 8mm bleeder nipples • Bleeds brake systems and hydraulic clutch systems • Internal check valve for fast and easy bleeding • Anodized billet aluminum handle with chrome moly steel body • Compact size for tight spaces • High quality internal seal • Multi position handle 08-080482


2013 Moto En
To see the actual publication please follow the link above